To begin the start-up process, fill the fuel tank with a 50:1 fuel mix.
We recommend using Craftop Brand Oil the proper fuel mix ratio.
Here is a link for a correct mix of oil and gasoline.
The priming bulb is located towards the bottom of the carburetor. Pump the bulb 5-7 times until fuel begins to flow through the fuel pipes.
Position the choke upright on a cold start (first start – right out of the box).
Set the throttle to 50%.
Pull the recoil starter 3-5 times to get the engine to start.
Push the choke down once you hear the engine flutter (turn over).
Set the throttle to 50%.
To start the engine, pull the recoil starter.
Allow the engine to warm up for 1-2 minutes at low throttle.
